The determination of the optimal cutting conditions for a stepped part is still one of the most difficult problems facing the production engineer. A computer program has been constructed to find the optimal cutting variables to minimize the production cost and to increase the rate of production and consequently the profit. The computer program is used to determine the optimum cutting variables for any number of steps and dimentions. These determined cutting variables can be applied for each step without changing the setting of the machine tool used.
MOUSSA, A. (1984). OPTIMIZATION OF STEPPED PART TURNING. The International Conference on Applied Mechanics and Mechanical Engineering, 2(1st Conference on Applied Mechanical Engineering.), 115-121. doi: 10.21608/amme.1984.50308
MLA
A. M.A. MOUSSA. "OPTIMIZATION OF STEPPED PART TURNING". The International Conference on Applied Mechanics and Mechanical Engineering, 2, 1st Conference on Applied Mechanical Engineering., 1984, 115-121. doi: 10.21608/amme.1984.50308
HARVARD
MOUSSA, A. (1984). 'OPTIMIZATION OF STEPPED PART TURNING', The International Conference on Applied Mechanics and Mechanical Engineering, 2(1st Conference on Applied Mechanical Engineering.), pp. 115-121. doi: 10.21608/amme.1984.50308
VANCOUVER
MOUSSA, A. OPTIMIZATION OF STEPPED PART TURNING. The International Conference on Applied Mechanics and Mechanical Engineering, 1984; 2(1st Conference on Applied Mechanical Engineering.): 115-121. doi: 10.21608/amme.1984.50308
)
View on SCiNiTO